C-COM Satellite Systems iNetVu 7710 - System Diagram with Splitter

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
16
5.4. System Diagram with Splitter
**Please Note: Using a splitter is optional. If the user does not wish to power the LNB from the
Controller, a splitter must be used such that power is passed to the LNB from the VSAT Modem
(or alternate power source).
Fig. 7: iNetVu
®
7710 Series Controller Splitter Connection Configuration
RX
GPS /Glonass
Antenna
iNetVu™ Mobile
Platform
TX
Satellite Modem / VSAT
!
100 - 240VAC
TX OUT
RX
RX IN
*Ground
protection
External
grounding
connection
24 VDC
Power input
COMBINED MOTOR
& DATA CONTROL
CABLE
Ensure Control Cable, including RX and TX cables are
connected prior to powering on 7710 Controller.
RG6 Coaxial Cable
Network Cable
Power Cable
Combined Motor & Data Control Cable
USB Cable
* Ground Connection