8 – LNB LO
Configurable to allow satellite accusation when frequency changes, values range from 10.75, 9.75, 10.00,
10.60 and 11.30.
The default value should be set to 10.75, the user is not required to change this value unless necessary,
otherwise select the carrier from the table or enter one if not listed.
9 - LNB Power (Target Satellite)
In cases where the LNB requires more power than the modem can provide, or if the user would like to
power LNB from the controller, or if the user would like to find satellite without the use of a modem, this
option allows for power from the controller to be supplied to the LNB through the RX IN cable from the
controller to the platform itself.
DD – will disable this option and provide power to the LNB straight from the modem. In this case,
a splitter must be used for the RF connection.
7.9.3. SR_CP
This menu allows for the configuration and saving of the Satellite Search Modes. The 64 Beams
which is the number of configurable Beams supported can be each configured with different RF
Search Mode parameters.
Fig. 33: Search Mode Configuration
1 – RF Search Mode
N RF Mode is disabled; Y will be displayed when enabled.
N RF override mode (second digit/letter) is disabled; O will be displayed when enabled.
RF Threshold (50) Value will be displayed here, this value is configurable.
2 – CP (Compass)
V Valid – The compass reading is functioning properly
N Normal – Full Search NOT selected, (nor is compass overridden).
O Override – the compass has been overridden, and direction entered manually considered
F Full Search – searches a full 360º search window, Fly-away systems (70 º), Full search
also overrides compass.
To Next Page
Loading...