4. Connect the Controller using the provided USB cable. Windows Vista and 7+ users, the
drivers should install automatically without any further user action.
5. You have successfully installed the 7710 iNetVu
®
Drivers and Software. Exit the setup
wizard.
6. You can now run the iNetVu
®
Mobile 7710 software from the shortcut on your desktop.
6.3. Setup
1. Connect all the cables and components as depicted in the previous section illustrating
the setup schematics. Select connection that is best suited for your application.
2. Power on the iNetVu
®
7710 Controller.
3. Set your external PC to the same subnet as the iNetVu
®
7710 Controller (Default
controller IP Address of the 7710 controller is (192.168.0.2) this IP could be different
depending on the service, it may be set to (192.168.0.3 or .4) Check the controller
configuration.
4. Refer to the appropriate service User Manual that will be used with your system for
addition setup and configuration information.
5. Controller should be power cycled (reset/rebooted) after each configuration change.
To Next Page
Loading...