C-COM Satellite Systems iNetVu 7710 - Error and Message Code Definitions

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
149
10.7. Appendix 7: 7710 Error/Message Code Definition
Error Code
Description
Comments
0X6330
Peaking Succ(INC)
0X7100
Detect AZ Stow Switch
0X7101
Detect AZ Stow Switch and RESET AZ Zero
Point
0X7102
Detect AZ Left Limit
0X7103
Detect AZ Left Limit and RESET AZ Angle
0X7104
Detect AZ Right Limit
0X7105
Detect AZ Right Limit and RESET AZ Angle
0X8000
Packet CRC Error
0X8001
System Busy
0X8002
DVB Module Error
0X8003
MCF5282 Interrupt Error
0X8004
Unknown Modem Command
0X8005
Re-send Command to Beacon Receiver
0X8006
Invalid DVB Carrier
0X8007
Peaking Failed
0X8008
SNMP Error
0X8009
DHCP Failed
0X8011
Command Rejected
0X8015
Re-send the command to DRC3500
0X8021
S File Error
0X8022
Can’t find ‘S’ file!
0X8023
S File too big!
0X8024
Erasing Failed!
0X8025
Programming Failed!
0X8030
No Reply(Remote)!
0X8040
Downloading S File Failed!
0X8050
CANBUS Reset(HW)
0X8051
CANBUS Overrun
0X8063
CANBUS Reset(SW)
0X8071
Enter ‘Install Mode’ Failed!
0X8072
Exit ‘Install Mode’ Failed!
0X8073
EL&AZ(SB2) Invalid!
0X8080
Beacon Receiver Frequency not valid
0X8081
Beacon Receiver DB not valid
0X8082
Stow Failed
0X80A0
Restoring failed (Compass), switching to Full
Search
ACP INFO
0X8100
AUTO ACP failed twice
0X8101
Can’t start MANUAL ACP(low isolation)