C-COM Satellite Systems iNetVu 7710 - Page 150

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
150
0X8102
AUTO ACP failed after MANUAL ACP
0X8103
ACP fatal error
0X8105
The first MANUAL ACP failed
Motion Detection/Tooway Look-up Table
0X8200
Failed to disable TX
Motion protection
0X8300
Look-up table for Tooway not available
0X8301
Can’t find beam in look-up table for Tooway
Read Carrier from Modem
0X8800
NETWORK RESET…
0X8826
TX polarity is not configured in option file
0X882B
Satellite longitude is not configured in option
file
0X882C
Frequency and Symbol Rate is not
configured in option file
0X882D
DVB Mode is not configured in option file
0X882E
RX Polarity is not configured in option file
Inclined Satellite Errors
0X8900
Can’t start peaking(INC)
0X8901
Peaking Failed(INC)
0X8910
System is running (in use)
0X8911
Sensor Error
0X8912
No Compass
0X8913
Satellite not visible
0X8914
GPS is not ready
0X8915
RF is too low
0X8916
MODEM/Beacon is not ready for RF search
0X8917
Antenna facing in the opposite direction.
Please rotate the antenna 180 degrees
0X8918
Compass not valid (After Restoring)
Errors from 7720 Remote Drive Module
0X9000
EL Over Current(Hardware)
0X9001
AZ Over Current(Hardware)
0X9002
PL Over Current(Hardware)
0X9003
EL Protection
0X9004
AZ Protection
0X9005
PL Protection
0X9006
EL JAM Error
0X9007
AZ JAM Error
0X9008
PL JAM Error
0X9009
EL Motor&Encoder Error
0X900A
AZ Motor&Encoder Error
0X900B
PL Motor&Encoder Error
0X9010
EL Current/Limit Protection
0X9011
AZ Current/Limit Protection
0X9012
PL Current/Limit Protection
0X9014
EL Protection Limit(UP)
0X9015
EL Protection Limit(STOW)
0X9016
EL Protection Limit(DOWN)