C-COM Satellite Systems iNetVu 7710 - Page 151

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
151
0X9018
AZ Protection ON EL Limit
0X9019
AZ END LIMIT1(Left) Protection
0X901A
AZ END LIMIT2(Right) Protection
0X9020
PL Protection ON EL Limit
0X9021
PL END LIMIT1(CCW) Protection
0X9022
PL END LIMIT2(CW) Protection
0X9030
EL Position Failed(20S)
0X9031
AZ Position Failed(20S)
0X9032
PL Position Failed(20S)
0X9035
EL Position Failed(Stag0~~3)
0X9036
AZ Position Failed(Stag0~~3)
0X9037
PL Position Failed(Stag0~~3)
0X903A
EL Position Failed
0X903B
AZ Position Failed
0X903C
PL Position Failed
0X90FE
Cannot find AZ/PL limit off status
0X90FF
Cannot find AZ/PL limit on status
0X9100
Cannot find satellite automatically (UN)
0X9101
Satellite not found (UN)
0X9102
Cannot stow (UN)
0X9120
Failed to find satellite
0XA000
Can't find satellite
0XA001
Skew adjustment failed
0XA002
Can't do Skew Adj/ACP(Signal low)
0XA003
Stow Failed(No AZ/PL ST)
0XA004
Cannot find AZ/PL limit off status
0XA005
Cal/Test Compass Failed
0XA006
Cannot find AZ/PL limit on status
0XA007
Failed to Disable TX
0XA009
Failed to go to the specified position
0XA00A
ACP is not available
0XA00B
Don't allow ACP to start
0XA00C
ACP did not start yet
0XA100
PL disabled
0XA150
Upload the recorded data failed
0XA151
Download the satellite parameter failed
0XA200
Write Internal Flash Failed
0XA201
Erase Internal Flash Failed
0XA202
Can't add new satellite (No room)
0XA210
BEAM ID not in Beam Table
0XA211
Satellite not in Satellite Table
0XA300
Can't move motor because of limit protection
0XA310
Can't enable modem(Signal low)
0XA311
Can't enable/disable TX
0XA320
Modem status wrong for force ranging
0XA321
Can't start force ranging
0XD000
CANBUS communication (EL) Failed
0XE000
CANBUS communication (AZ) Failed