8.4. Setup Wizard
The Setup Wizard has been implemented to aid first time users in configuring their system after
the software has been installed. A Pop-up window will show at first launch allowing the user to
use the Setup Wizard (select Yes) or to bypass it (select No) and use it later. Selecting “Cancel”
will exit the Setup Wizard. This window will show every time the iNetVuMobile7710 software is
executed, select “Do not show this message again” to allow software to go straight to the
Controls Window when the software is launched. The Wizard can be launched at any time as it
will be added as a menu option. See appendix for complete instructional steps on using the
Setup Wizard.
The Wizard will check Firmware and Software versions if “Yes” is selected to validate the
versions are the same and prompt the user to update the Firmware if they are different.
The wizard will automatically resume after the Firmware update has completed, follow onscreen
prompts. The wizard will not continue and go back to the previous window if “No” is selected.
To Next Page
Loading...