7.7.9. MD
This menu displays the modem status, beacon frequency and signal strength.
Fig. 25: Modem and Beacon Receiver
1 – Modem Communication Status, if the controller is still initializing communication with the
modem:
SQ - will appear with modem signal value after modem communication is establish
(Modem TX Disabled).
INIT - will appear if no modem communication.
NA - will appear if no modem selected.
2 – Beacon Receiver Frequency and Signal Strength
The Beacon Receiver is an optional unit that could be used to acquire satellite with the 7710 Controller.
See “iNetVu User Manual – Beacon Receiver” for details.
7.7.10. Hughes Modem Status (Only)
Fig. 26: Hughes Modem and Beacon Receiver
1 – Modem Communication Status, controller communication with the modem,
INIT - will appear if still initializing or no communication
NA - will appear if no modem selected.
SQ - Modem Signal Strength will appear after modem communication is establish
(Modem TX Disabled), Beam and Carrier will also appear depending on the selected
service/modem. First value is signal strength, second is Beam and third is Carrier.
2 – Displays the status of the (TX) satellite receiver transmit state
To Next Page
Loading...