5 – System Status (status meanings explained in the software section of this report)
AC ACP Testing
AE ACP Adjustment on Elevation (During Manual ACP)
AZ ACP Adjustment on Azimuth
AP ACP Adjustment on Polarization
CC Compass Calibration, Reading, Checking and Restoring
DT Testing
DN Downloading
EN TX Enabling
II Idle
IN Idle and in Inclined mode
LK Locking
MP Motion Detection
MM Manual Movement
PK Peaking
PS Positioning
RD Reading from Modem
SI System Initializing
SP Stopping
SR Searching
ST Stowing
UP Uploading
6 – Receive RF/DVB Signal
Receive RF Signal as measured from the LNB. The letter ‘N’ next to the RF Value indicates the
LNB is not being powered properly and there is an issue with the RF connection, whereas no
letter next to the RF value indicates the LNB is powered properly. When the system is not in RF
search Mode, and is searching via DVB carrier, the value represents the DVB signal, and the
letter “L” next to the value indicates a DVB signal LOCK.
7 – Modem Status
Displays the receive strength of the satellite, and the Modem/Transmitter Status.
D Transmitter Disabled
E Transmitter Enabled
U Unknown (Communication with Satellite Modem / VSAT has failed)
(E.g. M140D represents modem signal strength of 140, and transmitter is disabled)
8 – Beacon Receiver Signal
This section represents the strength of the Beacon Receiver Signal (if used). The letter ‘U’ next to
the Beacon Signal indicates an unlocked status, whereas the letter ‘L’ next to the Beacon Signal
indicates a Locked on satellite status.
To Next Page
Loading...