1- Platform Type
The user can configure the platform type using iNetVu LCD panel. See section 7.6 for
complete list of supported platforms.
A0755A - iNetVu
®
Ka-75V ver.10.x, New Gen Drive-Away 75cm (Ka - Band Circular)
A0756A - iNetVu
®
Fly-75V ver.1.x New Fly-Away 75cm (Ka - Band Circular)
A0986A - iNetVu
®
Fly-98G/H/V ver.1.x, 2 Axis New Fly-Away 98cm (Ka - Band Circular)
A0986B - iNetVu
®
Fly-98G/H/V ver.1.x, 3 Axis New Fly-Away 98cm (Ka - Band Circular)
A0987B - iNetVu
®
Drive-Away 98cm, SMC Refl. 3 Axis (Ka - Band Circular- Jupiter)
A0986C - iNetVu
®
Fly-981 ver.1.x, 3 Axis New Gen Fly-Away 98cm (Ku – Band, XPOL)
A1201A - iNetVu
®
1201J ver.10.x, New Gen Drive-Away, 1.2m Ku Band
A1206A - iNetVu
®
Fly-1202V ver.1.x, New Fly-Away 1.2m, Ka Band Viasat TRIA
A1206C - iNetVu
®
Fly-1202 ver.1.x, New Fly-Away 1.2m, Ku Band
A1805C - iNetVu
®
1801, New Gen Drive-Away, 1.8m Ku - Band
A1806C - iNetVu
®
Fly-1801, 3 Axis New Fly-Away 1.8m Ku – Band
2 – Platform Version Number
The user must select the platform version type to ensure the correct configuration parameters and
settings are referenced when operating the system. The platform version when selected will differentiate
hardware and software configuration on New Generation platforms which may affect the operation.
3 - Platform Serial Number
The user must enter the last five-digits of the platform serial number located on the iNetVu
®
Mobile or Fly-
away Platform. If platform and controller were purchased as a set, the number has been preconfigured for
you.
7.10.8. CC
This menu allows for the configuration of the controller input settings.
Fig. 40: Console Port and Controller Features
1 – Console Port Configuration
Used for the configuration of the console port on the 7710 Controller. The Console port could be used for
the following:
a) MDM (Modem Communication)
If the COM port is used to establish communication between the Controller and the VSAT
Modem (i.e. iDirect, Viasat, etc.), then MDM must be selected in this field, along with the
To Next Page
Loading...