3 – QPT (Es/No Value)
The Maximum energy to noise of a modem or SNR signal that can be configured to save time during the
satellite peaking routine. The peaking will transition from standard to quick once the configured Es/No
value is reached.
0---(threshold==55)
1---(threshold==85)
2---(threshold==115)
3---(threshold==145)
4---(threshold==175)
5---(threshold==205)
4 – DHCP Status
The 7710 Controller can be programmed to obtain an IP address from a DHCP Server (i.e.
modem, router, etc.).
D – DHCP Disabled (IP must be entered statically).
E – DHCP Enabled (Controller will dynamically obtain an IP address from the DHCP Server).
5 – Beep
This option allows for enabling and disabling the Beeping sound when navigating the LCD screen
through the front panel keypad.
D – Beep Disabled, the sound will be completely removed.
E – Beep Enabled, a beeping sound will occur every.
6 – TX Protection (TP)
The TX will be disabled and a 60 seconds waiting period will be endured before any
further action is applied when a small or big motion is detected. The system will re-peak
if the antenna is still locked on signal after the 60 seconds have elapsed or stow if no
signal exists. The 60 second waiting period will reset (start over during a 5min span) and
a new 60 seconds count will be started if motion is detected at any time during the 60
seconds waiting period. The antenna will stow after 5 minutes have elapsed whether it’s
locked on signal or not. System will redeploy and attempt to lock on satellite if stowed
and “unattended Operation” is enabled. See Unattended feature for more details. Motion
Detection will not trigger if Inclined Satellite is enabled as the later has a higher priority
and will instead be the one that activates.
D - Disabled
E – Enabled
To Next Page
Loading...