C-COM Satellite Systems iNetVu 7710 - Service (SR) Configuration

C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
55
1 – iNetVu
®
7710 Controller’s IP Address
2 – Modem IP Address
7.10.12. SR
This menu will allow the user to configure the controller to the service used (select modem type)
for 2-way satellite communication.
Fig. 44: SR (Service) Configuration
1 – Two-Way Mobile Service Selection
Before communication is established with the modem, the user must define the service in use. The
iNetVu
®
7710 Controller supports several services, including:
iDirect – iDirect Service
Tooway – Viasat Tooway Ka Service
VA_SB2 – Viasat SurfBeam2 Ka service
HNS_KU – Hughes Ku Service
HNS_KA – Hughes Ka Service
HNS_JT – Hughes Jupiter Service on HT series modems
COMTCH – Comtech Service
IPstar – IPstar Service
GILAT – Gilat Service on SkyEdge
NEWTEC – Newtec Ku service (OpenAMIP)
NV_SAT – NovelSat Service
DATUM7 – Datum Service
STM – STM Satlink service
NA - Stand Alone service - Used to locate and lock onto a manually configured satellite using the
DVB receiver unit inside of the controller independent of the modem. The manual configuration
requires:
▪ Orbital Slot of Satellite
▪ Receive Polarization
▪ DVB Type
▪ L-Band or Ku-Band Rx Frequency (kHz)
▪ Symbol Rate (ksps)
▪ FEC Code Rate
HNS_KU – TYPICAL - HT--0
YE(Y)NN
1
2
3
5
6
7
4