*Load 7710 Firmware (Main Controller Firmware)
Loads the iNetVu7710_Box_FW.S19 firmware file into iNetVu
®
Controller
from the iNetVu program folder. The update process is displayed on
screen and will notify the user when the process is complete. 7710
Controller will reset itself once the firmware updating is complete.
*Load 7720 Firmware (Remote Drive Module Firmware)
Loads the iNetVu7720_RTCTL_FW.S firmware file into iNetVu
®
Controller.
Reset
Restarts controller.
Restore
Resets all platforms to the manufacture’s default values, and resets
beam(s), and modem parameters settings to their defaults.
Download Log File
Downloads the log data from the 7710 Controller onto the user’s PC. The
user may select how much of the log file to upload from the Controller
section of this maintenance menu. The maximum data a user may upload
is 12 hours.
Save All
Sends and saves ALL parameters to the controller’s memory.
* Enabled ONLY when the 7710 controller is in Firmware loading mode.
To Next Page
Loading...