CAB SQUIX - Replacing the Power Supply Unit

14 14
2 Replacing Assembly Units
2.7 Replacing the Power Supply Unit
Danger!
Risk of death via electric shock!
 Before opening the housing cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
2
31
7
6
5
4
8
8
8
Fig. 9 Replacing the power supply unit
1. Unplug the printer from the electrical outlet.
2. Remove the rear cover.
3. Dismount cover (5), control panel (4) and cover (3).
4. Dismount the PCB CPU  2.6 on page 13.
5. Unplug the cables from the connectors (6,7).
6. Loosen 3 screws (8).
7. Loosen screw (2) and remove the power supply unit (1).
8. Insert the new power supply unit an x it with the screws (2,8).
9. Connect the cables at the connectors (6,7).
10. Re-mount the PCB CPU
11. Re-mount cover (3), control panel (4) and cover (5).
12. Mount the rear cover.