CAL Controls 3300 - SP2 Subsidiary Mode; SP2 as a Proportional Output; SP2 Alarm Condition Table; SP2 Alarm Annunciator

Second Setpoint
SUBSIDIARY SP2 MODE: SP2.B Latch/sequence or
non-linear cool.
Latch alarm
LtCh
When activated, the alarm latches until manually reset, even
though the alarm condition may have disappeared.
Sequence alarm
hoLd
When hoLd is selected, in any alarm mode, it prevents an
alarm signal on power-up. The alarm is enabled only when
the process temperature reaches setpoint.
TO CONFIGURE SP2 AS A PROPORTIONAL
CONTROL OUTPUT
In level 2 select SP2.A , then select the required option.
In level 1 select BND.2 and then set the required
proportional band.
In level 1 select SET.2 and then set the setpoint (SP2)
value (y°).
SP2 OUTPUT AND LED INDICATION STATES - IN
ALARM CONDITION
SP2 ALARM ANNUNCIATOR
When an SP2 alarm mode is selected in SP2.A the alarm
annunciator
-AL- is displayed, alternating with the process
temperature, during alarm condition.
Note: The annunciator may be disabled by selecting
function NO.AL , option
on in level 4.
SP2 in cool strategy
(See heat-cool configuration in ADVANCED SETTINGS page 23).
✱
Without sequence
alarm
Alarms on
power up
SP
setpoint
Y°
✱
Y°
SP
setpoint
SP
setpoint
SP
setpoint
No alarm on
power up
With sequence alarm
Alarm
enabled
Alarm operates
normally
Alarm type ON-OFF
operating mode
Proportional
operating mode
FS.HI
COOL
FS.LO
BAND
DV.LO
DV.HI
Deviation
Full scale
Strategy
SP2
Output state
SP2
LED state
SP2
Output state
SP2
LED state
BAND
: on-off mode only
Output ON
(Relay or SSd energised)
Output OFF
(Relay or SSd de-energised)
LED ON
Temperature above setpoint
13