To Next PageTo Next Page
Need help?Do you have a question about the CAL Controls 3300 and is the answer not in the manual?
General| Brand | CAL Controls |
|---|---|
| Model | 3300 |
| Category | Controller |
| Language | English |
Information about installation suitability and responsibilities.
Warning about using SP2 as the sole alarm for personal injury.
Step-by-step guide for initial controller configuration.
Procedure for selecting the correct sensor type.
Procedure for selecting the operating unit (°C, °F, etc.).
Procedure to select the primary output device.
Process to save initial configuration settings.
How to view and set the main setpoint value.
Required programming information after installation.
Explanation of the Autotune feature for controller tuning.
Steps to select input sensor and measurement unit.
Selecting SP1 output and saving initial settings.
Procedure to set the main setpoint value.
Explanation of the TUNE Autotune method.
Steps to start and exit the TUNE Autotune program.
Explanation of the TUNE AT SETPOINT Autotune method.
Steps to start and exit the TUNE AT SETPOINT Autotune program.
Methods for pre-selecting cycle time before or after Autotune.
Setting the controller to automatically accept Autotune cycle-time.
Manually setting the cycle-time before starting Autotune.
Feature for ramping temperature and soaking at a setpoint.
Indicates sensor faults and memory errors with actions.
Indicates failure during Autotune start and cycle.
Using the monitor to measure control stability.
Displaying software version and resetting functions.
Crucial note for OEMs regarding software security lock.
Configuring the Heat-Cool strategy for improved control.
Procedure for calibrating to an external instrument.
Procedure for calibrating linear process inputs.
Diagram showing typical electrical connections for Model 3300.
