2 Select unit.
Press and hold ✱ and use the ▲ or ▼ buttons to
scroll through the unit selection list
until the correct unit is displayed.
Release the buttons.
The display will now alternate
selected unit (eg. UNIT and
°C
).
Press ▲ once The display will now alternate
SP1.D and
nonE
3 Select SP1 (Main setpoint output device)
Note: Dual Relay and Dual SSd Output Options
Models 3311/9311 and 3322/9322 have
their outputs pre-configured. (see page 22)
Press and hold ✱ and use the ▲ or ▼ buttons to select
SSd
or
rLY
as required. The controller
will now alternate selected output device
(e.g. SP1.D and
SSd
).
Quick Start
QUICK START
1b
4 To enter initial configuration into controller
memory
Press and hold both ▲ and ▼ buttons for 3 seconds. The
display will now alternate
ParK
and
measured variable (temperature)
(eg.
23
)
ParK
is displayed
because a setpoint has not yet been
entered.
To display setpoint
Press and hold ✱ The display will now alternate
0
and
unit
(eg.
°C
)
To enter setpoint
Press and hold ✱ and use ▲ button to increase or ▼ button
to decrease the reading and scroll to
required setpoint value. (The digit roll-over
rate increases with time).
THE CONTROLLER IS NOW OPERATIONAL
WITH FACTORY SETTINGS
Note: For precise control of an application the controller
may need to be TUNED. Please study section
headed FUNCTIONS and OPTIONS before moving to
the section on AUTOTUNE.
To Next Page
Loading...
