EasyManua.ls Logo

CalderaSpas Elation - SAFETY INSTRUCTIONS; IMPORTANT SAFETY INSTRUCTIONS

CalderaSpas Elation
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
AVOIDING THE RISK TO CHILDREN
DANGER:
RISK OF CHILD DROWNING. Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents, ensure that children cannot
use a spa unless they are supervised at all times.
WARNING:
To reduce the risk of injury, do not permit children to use this spa unless they are closely supervised at all times.
To reduce the risk of injury, lower water temperatures are recommended for young children. Children are especially sensitive to hot water.
DO:
Make sure you always lock the child resistant locks after using the spa for your children’s safety. Every Caldera spa is equipped with a locking cover that meets
the ASTM F1346-91 Standard for Safety Covers.
Test the water temperature with your hand before allowing children to enter the spa to be sure that it’s comfortable. Children are especially sensitive to hot water.
Remind children that wet surfaces can be very slippery. Make sure that children are careful when entering, or exiting the spa.
DON’T:
Allow children to climb onto the spa cover.
Allow children to have unsupervised access to the spa.
AVOIDING THE RISK OF ELECTROCUTION
Risk of electrocution
Connect only to a grounded source. The spa must be connected to a Ground Fault Circuit Interrupter (GFCI). Watkins Manufacturing Corporation does not
supply a GFCI with the spa. Watkins recommends the GFCI be attached to the end of the spa’s electrical cord. The GFCI must be installed by a licensed,
qualified electrican. GFCI devices must meet or exceed all national and local electrical codes.
Do not bury the power cord. A buried power cord may result in death, or serious personal injury due to electrocution if direct burial-type cable is not used, or if
improper digging occurs.
A ground terminal (pressure wire connector) is provided on the surface of the control box inside the equipment compartment. This connector should be bonded
with a minimum 6 mm
2
(10 AWG) solid copper wire between this unit and any metal ladders, metal water pipes, metal enclosures of electrical equipment,
conduit or metal equipment within 1.5 m of the spa. If the spa is located on a reinforced concrete pad, the reinforced steel should also be bonded to the ground
terminal.
WARNING:
To reduce the risk of electrical shock, replace a damaged cord immediately. Failure to do so may result in death or serious personal injury due to electrocution.
Always test the Ground Fault Circuit Interrupter (GFCI) before each use of the spa. If the GFCI does not perform properly, a ground current is flowing indication
the possibility of electric shock. Disconnect power to the spa until the fault has been identified and corrected.
NOTE: Failure to wait 30 seconds before resetting the GFCI may cause the spa’s Power Indicator (on the control panel) to blink. If this occurs, repeat the GFCI
test procedure.
Install the spa so proper drainage is provided for the compartment containing the electrical components.
DANGER: RISK OF ELECTRICAL SHOCK
Install spa at least 1.5 m from all metal surfaces. A spa may be installed within 1.5 m of a metal surface if each metal surface is permanently connected by a
minimum 6mm
2
(10 AWG) solid copper conductor attached to the wire ground connector on the terminal box that is provided for this purpose.
Do not permit any electrical appliances, such as a light, telephone, radio, or television within 1.5 m of a spa. Failure to maintain a safe distance may result in
death, or serious personal injury due to electrocution, if the appliance should fall into the spa.
Install your spa in such a way that drainage is away from the electrical compartment and from all electrical components.
DO:
Be sure your spa is connected to the power supply correctly - use a licensed electrical contractor.
Disconnect the spa from the power supply before draining the spa or servicing the electrical components.
Test the Ground Fault Circuit Interrupter(s) before each use.
DON’T:
Use the spa with the equipment compartment door removed.
Place electrical appliances within 1.5m of the spa.
SAFETY INSTRUCTIONS

Table of Contents

Related product manuals