50
OPERATING INSTRUCTIONS
AIR CONTROL
The Air Control(s) located next to your spa-side control panel allows you to change the power of the jets by regulating the amount of air that is mixed with the water
coming out of the jets.
HYDRO JETS
AdaptaFlo
TM
Jets – The larger jets in your spa allow you to re-direct the jet stream by changing the position of the nozzle.
You can also regulate the force of the massage by rotating the jet face clockwise to reduce the force or counter-clockwise to increase the force. Notice that turning off
the flow to some jets increases the flow to the other jets. To avoid damage to your spa’s plumbing and components, do not turn off more than half of these jets at
the same time.
AdaptaSsage
TM
rotating nozzles are available from your dealer, to replace the directional adjustable nozzles in the AdaptaFlo
TM
Jets.
Euro Directional Jets – The small Euro jets deliver a direct, precision massage. You may also purchase Euro-Pulse
®
assemblies from your dealer that would replace the
Euro directional jets to provide a pulsating, rotary massage. This can be accomplished by simply twisting off the Euro jet face, adding the nozzle and nozzle retainer,
then reinstalling the Euro jet face.
DIVERTER VALVE
The diverter valve on the Cumberland
®
spa model allows you to direct the flow of water from the pump to several combinations of jets. The functions of this diverter
valve can best be learned by experimentation as follows:
1. Set all air controls to the “ON” position by rotating counterclockwise.
2. Turn on the pump.
3. Turn the handle on the diverter valve and see which groups of jets are affected. (Note that you can adjust the diverter valve to any position between the two
possible extremes to achieve the jet pressure that feels best to you.)
IMPORTANT: Your spa is not designed to provide full power to all jets when the diverter valve is in the “mid” position.
To Next Page
Loading...
