EasyManua.ls Logo

Caliber MCD795 - Connecting the GPS Antenna; Aerial to the unit; Installation Notes

Caliber MCD795
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FUSE
Roof
Rear shelf
Boot lid
Caution: Do not cut the GPS antenna / aerial lead to shorten
it or use an extension to make it longer. Altering the aerial
cable could result in a short circuit or malfunction and
permanent damage to the navigation system.
The aerial should be installed on a level surface where radio
waves will be blocked as little as possible. Radio waves cannot
be received by the antenna / aerial if reception from the satellite
is blocked. Installation on the vehicle roof or boot lid is
recommended to optimism reception.
When installing the GPS antenna / aerial inside the vehicle, be
sure to use the metal sheet provided with your system. If this is
not used, the reception sensitivity will be poor.
Do not cut the accessory metal sheet. This would reduce the
sensitivity of the GPS aerial.
Installing the GPS Antenna / Aerial
End user must read this section before installing the GPS
Antenna / Aerial.
GPS AERIAL
GPS AERIAL
5M
Note: Always use the provided screw
to fasten the GPS Antenna / Aerial.
SCREW
Connecting the GPS Antenna / Aerial to the unit
Installation Notes

Other manuals for Caliber MCD795

Related product manuals