72 BRIO 36 Audio Production System with Optional Networking GETTING SIGNALS IN AND OUT
Moving Paths to Different Faders
1. Select one or more faders, at least one of which must contain a path.
2. Tap MOVE in the control screen footer and tap the fader that is to be used to move the selected paths to.
3. Tap MOVE again to confirm choice.
Alternatively, once the chosen faders are selected, touch and hold again to make the selection float over the fader layout
screen. From here drag the selection across the screen to the desired location. As the user taps or drags across possible
destinations, previews of new path placements appear to help with their decision. The colour indication system described
above is used.
Once the user has selected the destination they are presented with three options: CANCEL; SWAP—swaps the original
paths with those on the chosen destination faders; OVERWRITE —replaces the destination path with the original
selection and removes the destination paths from the surface. As channels don’t exist once they are removed from a
fader a pop-up appears if an attempt to overwrite a channel occurs requiring a confirmation of choice.
Deleting Paths from Faders
To remove a path from a fader:
1. Select one or more faders, at least one of which must have a path attached.
2. Tap DELETE in the screen footer.
As channel paths don’t exist once they are removed from faders, if the user attempts to delete a channel, a pop-up
appears showing the paths that will be deleted, requiring a confirmation of selection.
Lock a Fader to the Surface
Layer lock allows the user to ensure some faders are always present on the surface, regardless of which layer is selected.
1. Select one or more faders (with or without paths attached).
2. Tap LOCK in the screen footer.
The selected faders are then locked to the surface and will remain there regardless of layer selection.
To Next Page
Loading...