How to troubleshoot CAME FROG that will not respond when given a command?
If your CAME Gate Opener isn't responding to commands, try the following: 1. Check the power supply to the control panel. 2. Check the control panel fuses. 3. Verify the hard wire link is fitted between terminals 1 & 2. 4. Ensure that capacitors are fitted and wired correctly.
Why my CAME FROG won't respond to remote control command?
There are several reasons why your CAME Gate Opener might not be responding to the remote control: * The AF frequency card might not be fitted to the control panel. * The remote control may not have been programmed into the control panel. * The remote control could have the wrong code setting. * 'Operator Present' might not have been selected, deactivating radio remote controls (DIP switch 1). * The wrong frequency card may be fitted for the remote control.
What to do if my CAME FROG is open but will not close and the green LED is flashing?
If your CAME Gate Opener is stuck open and the green LED is flashing, here's what you can check: 1. Ensure the safety beams are wired correctly. If you have multiple sets, they must be wired in series. 2. Confirm that the safety beams are receiving power. Restore power if needed. 3. If safety beams aren't installed, make sure a hard wire connects terminals 2 & C1. 4. Remove safety beam wires 2 & C1 from the control panel and check for a normally closed circuit coming from the beams.
Why CAME FROG automatically opens but does not automatically close after commissioning?
If your CAME Gate Opener opens automatically during commissioning but doesn't automatically close, consider the following: 1. The motor wires might be incorrectly connected. Verify the motor direction by briefly pulsing terminals 2 & 3; the gate should open. 2. Turn off automatic closing (DIP switch 2) until the motor direction has been verified.
Why does my CAME Gate Opener open but not close?
If your CAME Gate Opener opens but does not close, the photocells might be engaged. Check that the photocells are clean and in good working order. If this is not the cause, it is recommended to call assistance.
What to do if CAME FROG Gate Opener will not open or close?
If your CAME Gate Opener isn't opening or closing, here's what might be happening: * **No Power:** Ensure the power supply is active. * **Remote Batteries:** Replace the remote control batteries if they're depleted. For other potential issues like a released gearmotor, broken transmitter, stuck or broken stop button, or stuck opening/closing button/key selector, it's recommended to call assistance.
General| Motor Voltage | 24 V DC |
|---|---|
| Max Gate Weight | 800 kg |
| Duty Cycle | 30% |
| Limit Switch | Yes |
| Power Supply | 230 V AC |
| Safety Features | Obstacle detection |
| Type | Electromechanical underground gate opener |
To Next Page
