EasyManuals Logo

CAME V6000P User Manual

CAME V6000P
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Page 4 - Manual FA01799 -EN - 04/2022 - © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
includes a pedestrian gate, unless it can only be enabled when the pedestrian gate
is secured. • The operator must not be used with guided parts that have openings
exceeding 50 mm in diameter, or that have protruding edges/parts someone could
grab or stand on. • Make sure that nobody can become trapped between the guided
and fixed parts, when the guided part is set in motion. • All fixed controls must be
clearly visible after installation, in a position that allows the guided part to be directly
visible, but far away from moving parts. All fixed controls must be installed at least
1.5 m above the floor. • Where operated with a hold-to-run control, install a STOP
button to disconnect the main power supply to the operator, to block movement of the
guided part. • Install the manual release device below 1.8 m. If the manual release
device is removable, store it somewhere near the operator. • If not already present,
apply a permanent label describing how to use the public manual release mechanism
close to it. • Make sure that the operator has been properly adjusted and that the
safety and protection devices and the manual release are working properly. • Following
installation, ensure that the guided part does not extend onto any public footpaths
or roads. • Before handing over to the final user, check that the system complies
with the harmonised standards and the essential requirements of the Machinery
Directive (2006/42/EC). • Permanently affix the risk of entrapment labels somewhere
visible or near any of the fixed controls. • Any residual risks must be indicated clearly
with proper signage affixed in visible areas, and explained to end users. • Put the
machine’s ID plate in a visible place when the installation is complete. • If the power
supply cable is damaged, it must be immediately replaced by the manufacturer or by
an authorised technical support service, or in any case, by qualified staff, to prevent
any risk. • Keep this manual inside the technical folder along with the manuals of
all the other devices used for your automation system. • Make sure to hand over
to the end user all the operating manuals of the products that make up the final
machinery. The product, in its original packaging supplied by the manufacturer, must
only be transported in a closed environment (railway carriage, containers, closed
vehicles). • If the product malfunctions, stop using it and contact customer services
at serviceinternational@came.com or via the telephone number on the website.
The manufacture date is provided in the production batch printed on the product label. If necessary,
contact us at https://www.came.com/global/en/contact-us.
The general conditions of sale are given in the official CAME price lists.
Page 4 - Manual FA01799 -EN - 04/2022 - © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructions

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CAME V6000P and is the answer not in the manual?

CAME V6000P Specifications

General IconGeneral
BrandCAME
ModelV6000P
CategoryGarage Door Opener
LanguageEnglish

Related product manuals