CAME VER12 - Programming the Closing Slow-Down (min. 600 mm from the final closing strike or max. 50% of the door travel)

#,3%.3
/03%.3
/0%.
/0#,
!&
%.#2!$)/
#,3%.3
/03%.3
/0%.
/0#,
!&
%.#2!$)/
#,3%.3
/03%.3


/.
!#4
3,/73%.3
/03%.3
/0%.
/0#,
!&
%.#2!$)/
#,3%.3
/03%.3


/.
/0%.
/0#,
!&
.

%
%.#2!$)/
!#4
3,/73%.3
/03%.3
/0%.
/0#,
!&
%.#2!$)/
p.
20
20 - Manual
FA00045-EN
FA00045-EN v.
2
2 - 09/2016 - © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Press the OP/CL button until the door reaches the desired end slow-down point  - Press the ENC/RADIO
button until the LED stays on to signal that memorization is now complete .
Reset DIP-switch 1 to OFF .
Programming the closing slow-down (min. 600 mm from the final closing strike or max. 50% of the door travel)
When the door is fully closed, press the ENC/RADIO button, the LED will fl ash rapidly .
Set DIP-switch 2 to ON, the LED turns o .
Release the ENC/RADIO button, the LED fl ashes slowly .