25
DMX
DEUTSCHFRANCAIS
ESPAÑOL
ENGLISH
ITALIANO POLSKI
4. Place the module on a clean, level surface with the gobo wheels facing upwards. To avoid
contaminating the gobos and other components, please wear clean, lint-free gloves.
5. Lift the gobo holder slightly up on the gear and then pull it out of the gobo wheel.
6. The gobo can now be removed from the holder and replaced with another one.
7. Then place the gobo holder back into the respective gobo wheel, ensuring that the gobo holder
is correctly positioned in the corresponding recess. For rotating gobos, you can check that the
gobo is positioned correctly by turning the gobo wheel. The gobo must rotate without catching.
8. Re-install the module in the light head, secure it with the two previously loosened screws, and
reconnect the plug for the power and signal supply to the corresponding port.
9. Re-attach the cover’s safety cable to the corresponding position in the device head, place the
cover on the device head, and secure it with the four locks (bayonet lock, 1/4 turn to the right).
To Next Page
Loading...
