SPECIFICATIONS
MODEL
SPYDER RS (CE)
ELECTRICAL SYSTEM
Magneto generator output 500 W
Ignition system type Electronic ignition with dual output coil
Ignition timing Not adjustable
Quantity
2
Make and type
NGK DCPR9E (apply heat-sink paste P12 (P/N 420 897
186) on spark pl
ug threads)
Spark plug
Gap
0.7 mm - 0.8 mm (.028 in - .031 in)
Engine RPM limiter setting Forward 10 000 RPM
Type Maintenance free
Voltage 12 volts
Nominal rating 21 A•h
Battery
Recommended charging rate 2 A
Headlight 4X60W
Tail light/brake light 2X5/21W
Front 21 W
Turn signal lights
Rear 21 W
Position lights 2X5W
License plate light 10 W
Fuses
Refer to
FUSES
in
ELECTRICAL ACCESSORIES FAILURE
in the appropri
ate
OPERATOR'S GUIDE
FUEL SYSTEM
Fuel delivery Type
Multi-point El
ectronic Fuel Injection (EFI) with dual
57 mm throttle body
Fuel pump Type Electrical module in fuel tank
Idle speed 1400 ± 100 RPM (not adjustable)
Type Regular unleaded gasoline
Fuel
Octane no. 92 RON or higher
Fuel tank capacity
25 L (6.6 U.S. ga
l.)
DRIVE SYSTEM
Final drive typ
e
Carbon reinfor
ced drive belt
Final drive ratio 28/79
STEERING
Type Dynamic Power Steering (DPS)
FRONT SUSPENSI
ON
Suspension type Double A-arm with anti-roll bar
Suspension travel
144 mm (5.7 in)
Qty
2
RS Oil damperShock absorber
Type
RS-S Gas
RS
5 position cam adjustment
Front preload adjustment
RS-S
Threaded rings
PREDELIVERY 2012-1 35 / 37
To Next Page
Loading...
Need help?
General
