PARTS TO BE INSTALLED
NOTICE
Front wheels have to stay straight to
avoid contact between bottom of fender and
skid wheels guide.
3. Assisted by another person, move vehicle rear-
ward out of the crate base.
NOTICE
Always move vehicle rearward out of
the crate base.
rbl2010-002-021_a
TYPICAL (R
T M ODEL SH OWN)
PARTS TO BE
INSTALLED
Battery
rmo2008
-001-029_d
1. Battery location
NOTE: Refer to the latest edition of
CAN-AM
ROADSTER BATTERIES SERVICE BULLETIN
for
proper activating, charging and maintenance pro-
cedures.
1. Open seat.
2. Remove
LH and RH upper side panels.
2.1 Cut locking tie retaining front screw and
panel nut.
rbl2011-002-003_a
1. Locking tie
2. Front panel screw
3. Panel nut
2.2 Remove rear panel screws.
rbl2011-002-004_a
1. Rear pan
el screws
2.3 Install the previously removed panel nut on
lateral bracket.
rbl2011-002-005_a
1. Panel nut
3. Remove LH rear panel.
3.1 Remove and keep plastic rivets located un-
der seat.
6 / 37 2012-1 PREDELIVERY
To Next Page
Loading...
Need help?
General
