6. If you installed a new HDD, install system software (see “Installing System Software” on page 46).
A spare HDD is shipped without preinstalled system software.
7. Make sure to configure the date and time in Setup (see “To configure the system date and time” on page 25).
8. Before you leave the customer site, verify the imagePRESS Server operation.
• Connect the imagePRESS Server to the network (see “imagePRESS Server connector panel and LED diagnostic
codest” on page 17).
• Ask the site administrator to check the Setup options (see Configuration and Setup).
3. REPLACING PARTS
44
To Next Page
Loading...