23.
< Without the Finisher >
< With the Finisher >
24. Connect the power plug of the host machine to the
outlet.
NOTE:
With a 120V machine, install the cord retainer.
25. Turn the main power switch ON.
Checking after Installation
1. Check the model of the Card Reader in service mode.
COPIER > OPTION > ACC > CR-TYPE(Default: 0 "Card
Reader-F1")
2. Set the number of card (number of department ID)
that can be used with the Card Reader in service
mode(Lv.2).
COPIER > OPTION > FNC-SW > CARD-RNG
3. Use Service Mode to enter the minimum card
number to be used by a user (1 to 2001).
COPIER > FUNCTION > INSTALL > CARD
CAUTION:
• Starting from the entered card number, the
number of cards set in step 2 can be used.
4. Turn OFF and then ON the main power switch to
enable the setting values.
9. Installation
610
To Next Page
Loading...
Need help?
General