Setting Item Description, Instructions
Adjust
Printer
Feed
Priority
Adj.
Quality
Auto(OtherPaper) The printer prints and reads a test pattern for automatic ad-
justment of the feed amount. Note that this function takes
more time and consumes more ink than Auto(Genu-
inePpr). (See "Automatic Banding Adjustment.") ➔P.582
Manual Use this mode with highly transparent media or other paper
for which Auto(GenuinePpr) or Auto(OtherPaper) cannot
be used.
Print a test pattern for adjustment of the feed amount based
on the type of paper. (See "Manual Banding Adjust-
ment.") ➔P.584
Adjust
Length
Adjust-
ment-
Print
A:High Print a test pattern for particular types of paper to compen-
sate for paper stretching or shrinkage, after which you enter
the amount of adjustment. (See "Adjusting Line
Length.") ➔P.586
B:Standard/Draft
Change
Settings
A:High Displayed when you have selected Feed Priority > Adj.
Priority > Print Length.
Adjustment relative to the amount of stretching or shrinkage
of the current paper.
Enter either the adjustment results from AdjustmentPrint
or the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower ad-
justment value. (See "Adjusting Line Length.") ➔ P.586
B:Standard/Draft
Mainte-
nance
Head Cleaning Clean the Printhead. (See "Cleaning the Print-
head.") ➔P.600
Choose Head Cleaning A if printing is faint, oddly colored,
or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or if
printing is not improved by Head Cleaning A.
Nozzle Check Print a test pattern to check the nozzles.
Replace P.head Execute when replacing the Printhead. Follow the instruc-
tions displayed to complete the required procedure. (See
"Replacing the Printhead.") ➔ P.601
Not displayed during a warning message that the remaining
Maintenance Cartridge capacity is low.
Repl. maint cart Execute when replacing the Maintenance Cartridge. Follow
the instructions displayed to complete the required proce-
dure. (See "Replacing the Maintenance Car-
tridge.") ➔P.608
Head Info Indicates information about the printhead.
GL2 Set-
tings
Quality
Manager
Color
Mode
Monochrome Print in monochrome.
Color (CAD) 1 Print in standard colors.
Color (CAD) 2 Print with approximate colors emulating Canon iPF750,
iPF755, iPF650, iPF655, iPF760, iPF765.(*2)
Color (CAD) 3 Print with approximate colors emulating Canon iPF500,
iPF600, iPF700, iPF510, iPF610, iPF710, iPF605, iPF720,
iPF810, iPF820, iPF815, iPF825.(*2)
Color (CAD) 4 Print emulating the HP Designjet 500/800, in colors resem-
bling colors produced by these printers.(*2)
Color (CAD) 5 Print emulating the HP Designjet T1100, in colors resem-
bling colors produced by this printer.(*2)
iPF685
Menu Settings
User's Guide
Control Panel Printer Menu
463
To Next Page
Loading...
