Other problems
Other problems
The Ink Tank Cover has become detached from the printer .............................................................................. 653
The printer does not go on ................................................................................................................................................ 653
The printer takes time to start up ...................................................................................................................................653
If the Printer Makes a Strange Sound ...........................................................................................................................654
Messages advising to check the maintenance cartridge are not cleared ..................................................... 654
The printer consumes a lot of ink ................................................................................................................................... 654
Ink Level Detection ................................................................................................................................................................ 654
The Ink Tank Cover has become detached from the printer
The Ink Tank Cover has become detached from the printer
Cause Corrective Action
The Ink Tank Cover became detached from the printer because too much
force was applied to the Ink Tank Cover.
Attach the Ink Tank Cover to the printer.
(See "Attach the Ink Tank Cover to the printer.") ➔ P.597
The printer does not go on
The printer does not go on
Cause Corrective Action
The printer is unplugged. Plug the power cord into the outlet, and then turn on the printer.
The specified voltage is not supplied. Check the voltage of the outlet and breaker.
(See "Specifications.") ➔P.682
The printer takes time to start up
The printer takes time to start up
Cause Corrective Action
The printer may have shut down incorrectly last time. This may happen
after power outages or if the printer is unplugged before it is turned off.
In this case, the next time power is restored, the printer's hard disk is
checked, and startup may take some time.
Please wait a while, because it may take several minutes to
finish checking the hard disk.
If an error message is displayed after the hard disk check, fol-
low the instructions indicated to resolve the problem.
iPF685
The Ink Tank Cover has become detached from the printer
User's Guide
Troubleshooting Other problems
653
To Next Page
Loading...
