3-42
Managing the Printer Using FTP Client
Managing the Printer in the Network Environment
3
Managing the Printer Using FTP Client
You can manage the printer with FTP Client using the following procedure. Also,
you can upgrade the firmware.
1
Run Command Prompt or MS-DOS Prompt.
For Windows XP/Server 2003: From the [Start] menu, select [All Programs] ➞
[Accessories] ➞ [Command Prompt].
For Windows 2000: From the [Start] menu, select [Programs] ➞ [Accessories]
➞ [Command Prompt].
For Windows Me: From the [Start] menu, select [Programs] ➞ [Accessories] ➞
[MS-DOS Prompt].
For Windows 98: From the [Start] menu, select [Programs] ➞ [MS-DOS Prompt].
2
Enter the following command, then press the [ENTER] key on
your keyboard.
ftp <the IP address of the printer>
NOTE
If you are not sure about the IP address of this printer, refer to the Network Status
Print printed in "Checking the Operations with Network Status Print" (p. 2-57) or
ask an administrator of the printer.
3
Enter "root" as the user name, then press the [ENTER] key on
your keyboard.
If a password is specified for the printer, enter the password. If the password has
not been specified yet, do not enter the password, but press the [ENTER] key on
your keyboard.
NOTE
You can log in by entering a name other than "root" (or leaving the field blank). In
this case, you can perform operations other than settings.
To Next Page
Loading...
