5-2
Network Setting Items
Appendix
5
Network Setting Items
You can change the settings for the network board by using the web browser
(Remote UI), FTP Client, or NetSpot Device Installer. The following are the setting
items that you can change.
NOTE
•
The letters shown in parentheses are exclusively for FTP Client (Example: "Device Name
(DEVICE_NAME)" is indicated as [Device Name] in the Remote UI and NetSpot Device
Installer, and indicated as [DEVICE_NAME] in the config file in the FTP Client).
•
The asterisk marks attached to the end of some option names, such as "*1", indicate the
following:
*1: Cannot be specified using NetSpot Device Installer. Specify these options using the Remote UI or FTP
Client.
*2: Can be specified using FTP Client only.
■
General Settings
Option
Contents Default
[Print Server Name]
(PS_NAME) *
1
The name of the network board (print
server) (0 to 15 characters)
CANONX
XXXXX
[Device Name]
(SYS_NAME)
The name of the device (0 to 32
characters)
(Blank)
[Location]
(SYS_LOC)
The installation site of the device (0 to 32
characters)
(Blank)
[Administrator]
(SYS_CONTACT)
The name of the administrator of the
device (0 to 32 characters)
(Blank)
[Phone]
(SYS_CONTACT_TEL) *
1
The telephone number of the
administrator of the device (0 to 32
characters)
(Blank)
[Comments]
(SYS_CONTACT_COMMENT) *
1
Comments by the administrator of the
device (0 to 32 characters)
(Blank)
(SERVICE_MAN_NAME) *
2
The name of the service person (0 to 32
characters)
(Blank)
(SERVICE_TEL) *
2
The telephone number of the service
person (0 to 32 characters)
(Blank)
(SERVICE_COMMENT) *
2
Comments by the service person (0 to 32
characters)
(Blank)
To Next Page
Loading...
