6-30
Printing Environment Settings
6
SETUP Menu Settings
*3 WSD BROWSING is displayed only when WSD PRINT is set to OFF.
Specifies the TCP/IP setting for the print server equipped with this printer.
Item Setting
IP MODE
Select the method for setting the IP address.
-When specifying the IP address using any one of DHCP,
BOOTP, or RARP, select AUTO.
-When specifying the IP address to the printer directly, select
MANUAL.
PROTOCOL
If you have set IP MODE to AUTO, select which protocol you
want to use.
Set each of DHCP, BOOTP, and RARP to ON (use) or OFF (do
not use).
IP SETTINGS
Specify the settings for IP ADDRESS, SUBNET MASK, and
GATEWAY ADDRESS.
For the method for entering the addresses, see "Method for
entering addresses" below the table.
To Next Page
Loading...
