Canon LBP 3370 - Start Wait Time; Remote Ui Set; Ethernet Driver

6-35
Printing Environment Settings
6
SETUP Menu Settings
■ START WAIT TIME
0 to 300 seconds; 0 seconds*
Specifies the time interval from when the printer is turned ON to when the protocol
starts.
NOTE
• For more details on startup waiting time, see "Chapter 2 Common Network
Settings" in Network Guide.
• This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
■ REMOTE UI SET.
REMOTE UI ..........................ON*, OFF
Specifies whether the printer should use the Remote UI.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
■ ETHERNET DRIVER
AUTO DETECT.....................ON*, OFF
COMM.MODE*
1
....................HALF DUPLEX*, FULL DUPLEX
ETHERNET TYPE*
1
.............10 BASE-T*, 100 BASE-TX
MAC ADDRESS....................(Display only)
*1 COMM.MODE and ETHERNET TYPE are displayed only when AUTO DETECT is set to OFF.
Configures the Ethernet driver.
NOTE
• For more details on configuring the Ethernet driver, see "Chapter 2 Common
Network Settings" in Network Guide.
• This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.