6-33
Printing Environment Settings
6
SETUP Menu Settings
"Method for entering addresses"
1. Move the cursor to each field (an area separated by periods to enter three-digit
numbers) in which you want to enter the address, by pressing
[] or [ ]
(The
number in the field blinks, allowing you to enter a value.).
2. Enter the numbers (
[]
increases the value and
[]
decreases the value.).
3. After entering values in all the fields, press [OK] to confirm the settings.
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
■ APPLETALK
OFF*, ON
Specifies whether the printer should use AppleTalk.
NOTE
•
For more details on AppleTalk, see "Chapter 6 Using the Printer on an AppleTalk
Network (Macintosh)" in Network Guide.
•
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
■ SMB
SMB SERVER ......................OFF*, ON
Specifies whether the printer should use the SMB protocol.
NOTE
This item is displayed only when NETWORK in the I/F CONNECTION options is
set to ON.
MAC
ADDRESS
SET
Permits access only from users with a specific MAC address.
Set PERMIT RECEIVE to ON, and then specify the addresses
to be permitted in PERMIT ADD.SET..
Enter addresses in PERMIT ADD.SET. using the following
procedure.
a Select PERMIT ADD.SET., then press [OK].
b Select PER.MAC ADD.1 then press [OK].
c Enter the MAC address to be permitted, then press [OK].
d If you want to enter other MAC addresses to be permitted,
enter them starting from PER.MAC ADD.2.
You can enter up to 50 addresses.
Item Setting
To Next Page