3-3
Power Saving (Power Save Mode)
Using the Printer
3
■ Power Save Mode 2 (Deep Sleep Mode) ... Power-saving effect: Large
The printer enters Power Save Mode 2 when it is in the following condition.
*Even when SMB SERVER is set to ON, the printer enters Power Save Mode 2 if the "server name" for SMB is not
entered.
IMPORTANT
Even if POWER SAVE MODE is set to PANEL OFF or OFF, the printer enters Power
Save Mode 2 when [Deep Sleep] is executed in [Device Control] in the Remote UI.
NOTE
•
When the printer enters Power Save Mode 2, only the Power indicator comes on.
•
Power Save Mode 2 can be released when the printer is in any of the following status:
-When the (Online) key on the control panel is pressed
-When the printer receives data from the computer (Only when the printer is online)
- The settings for [Utility Menu] are specified in the Remote UI
•
The printer does not enter Power Save Mode 2 in the state where a DHCP
communication can be done.
Condition
POWER SAVE MODE is set to DEEP SLEEP.
The printer has already entered Power Save Mode 1.
USB in I/F CONNECTION is set to OFF.
APPLETALK in NETWORK MENU is set to OFF.
SMB SERVER in NETWORK MENU is set to OFF*.
There is no job on the print queue.
The printer has not communicated on the network for more than 15 seconds.
To Next Page
Loading...
