In order to use MEAP functions from the Web browser, HTTP communication must be enabled.
Follow the steps in the procedure below to configure the settings. (The default settings are <On>.)
1
Press [Settings] key, select <Network> with , and then press [OK] key.
After the message is displayed, press [OK] key.
2
Select <TCP/IP Settings> with , and then press [OK] key.
3
Select <HTTP> with , and then press [OK] key.
4
Select <On> with , and then press [OK] key.
5
Perform a hard reset or restart the printer.
The settings are enabled after a hard reset or after the printer is restarted.
<On> It uses HTTP.
<Off> It does not use HTTP.
NOTE
Details about Hard Resets
See the "e-Manual."
Setting Up HTTP Communication
3
To Next Page
Loading...
