Preparing the Camcorder
24
Wireless Controller
First, insert the supplied CR2025 lithium button battery into the
wireless controller.
1Press the tab in the direction of the arrow (햲) and pull out
the battery holder (
햳).
2 Place the lithium button battery with the + side facing up
(
햴).
3Insert the battery holder (
햵).
To use the wireless controller
Point the wireless controller at the camcorder’s remote sensor when
you press the buttons.
• You can rotate the LCD panel 180 degrees to use the wireless
controller from the front of the camcorder.
• When the camcorder cannot be operated with the wireless controller,
or when it can only be operated at very close range, replace the battery.
• The wireless controller may not work properly when the remote sensor is situated under strong light sources or
direct sunlight.
To Next Page
