OPERATOR MANUAL |CAPTAIN 273 4WD 55
4.14 2WD-4WD Levers
The lever has two positions viz. forward 4WD and backward 2WD on the tractor.
In (fig.4-7). The purpose of the front drive is to increase traction on broken ground,
mud and slippery surfaces etc. The control lever is used to engage and disengage
the front drive. Both maneuvers can be carried out whilst the tractor is driving in a
straight line and never under stress.
NOTE: Only use four-wheel drive when strictly necessary. Avoid use of 4WD
when maximum traction is not required, e.g. on hard ground, roads, etc.,
since this would only increase tyre wear unnecessarily. Always leave the
4WD lever engaged when parking on slopes with the trailer connected.
WARNING: Never use the 4WD engaged while driving at higher speeds.
Always use only when high traction is required.
4.15 PTO lever
The lever has two positions viz. ground PTO, neutral position and live PTO
position. (Fig. 4-8).
PTO lever ON – OFF position
Lever Backward: PTO in neutral position.
Lever Forward: PTO engaged.
Power take-off
The tractor is equipped with a standard power take off
that complies with international regulations. It is installed
at the rear of the transmission housing.
• Directly from the engine: Independent PTO mode.
• 4 Various speed in PTO.
To Next Page
Loading...
