OPERATOR MANUAL |CAPTAIN 273 4WD 65
WARNING: Never tow with the top link connected to the swinging support of the
hydraulic power lift
4.35 Top link of the mechanical power lift 2(Fig.4-16).
The top link has two holes for hitching the implement and
adjusting its slant. It also provides a means of adjusting draft
control sensitivity, which should be chosen according to the
type of implement used
• Fix top link to the lower hole for greater sensitivity (1)
• Fix the top link to the upper hole for less sensitivity or if
jerking is observed.
4.36 Safety structure
The tractor is equipped with a ROPS (Roll over protection safety
structure) (Fig.4-38) mounted behind the driving seat and approved
according to the CURRENT OECD and EEC STANDARDS. The
protective structure is formed by two parts, one upper and one lower,
which are bolted together.
The tractor must only be used with the protective structure in the
upright position (Fig. 4-17).
WARNING: The tractor could tip up if used incorrectly.
Protection is only guaranteed when the protective structure
is in its original upright position with the fixing bolts
tightened as described in the assembly instructions.
To Next Page
Loading...
