OPERATOR MANUAL |CAPTAIN 273 4WD 64
WARNING: Before getting off the tractor, always lower to the ground any implement that is
mounted on the three-point linkage.
WARNING: NEVER work underneath an implement held up only by the hydraulic power lift and
three-point linkage. Support the implement for safety and stop the tractor engine
4.32 Mechanically controlled power lift
The power-lift control levers are used to set the following modes (Fig.
4-15.)
• Position lever (Black Color)
• Draft lever (Red Color)
Each of these modes must be chosen according to the type of work in
hand, the type of implement and the consistency of the soil.
4.33 Position lever
Move the draft lever to the lower stop. Set the position of the
implement, either in or out of the soil, by moving the position
lever toward the upper stop to raise it, or towards the lower stop
to lower it. The degree to which implement is moved is
proportional to the degree to which the position lever is shifted.
4.34 Draft lever
Move the position lever to the lower stop and set the implement
to the required depth by slowly moving the draft lever towards the lower stop. The depth reached by
the implement is proportional to the traction required by the consistency of soil. The tractive force
required from the tractor is automatically kept constant in these conditions by the power lift. Lock the
lower stop in front of draft lever to bring it to the same position each time round .Raise the implement
at the end of each furrow by using the position lever only. At the end of the stroke of draft lever is
engaged and power lift no longer controls the traction force.
To Next Page
Loading...