OPERATOR MANUAL |CAPTAIN 273 4WD 73
CAUTION: Use your own discretion and experience when deciding the actual intervals for
variable interval service and maintenance operations. Always remember, however, that is
better to perform them too often than not often enough.
CAUTION: Change the engine oil and relative filter cartridge after the first 50 hours work.
After this, change the engine oil and engine oil filter at the intervals given in the 'Routine
Maintenance Table'.
CAUTION: Replace the fuel filter at the intervals specified in the 'Routine Maintenance
Table'
5.2 Lubrication and maintenance
Read and comply with all the safety precautions in the tractor maintenance part of the
Safety Notes Section.
NOTE: Old fluid and used filters must be disposed of in the correct way.
WARNING: Do not carry out inspections, maintenance work or adjustments on the tractor
while the engine is running.
5.3 Sealed units
Do not remove the seals from the following parts: injection pump and over speed screw. If you need to
repair or adjust any of these units, contact your local dealer or authorized repair shop. The warranty is
automatically invalidated if these seals are tampered with.
5.4 Running in
Fade-free efficiency and a long working life largely depend on how the new tractor is treated during the
running in period. It is therefore extremely important to follow these instructions:
• Your engine does not require any special running in when new. You can use it at full power from the
start but you must never overload it. Avoid using the engine at full power before it reaches an
operating temperature of at least 60°C (140° F).
• Avoid idling the engine for long periods.
• Regularly check for oil leaks.
To Next Page
Loading...
