OPERATOR MANUAL |CAPTAIN 273 4WD 74
5.5 After the first 50 hours
Change the engine oil. After this, change the engine oil and engine oil filter at the intervals given in the
'Routine Maintenance Table".
• Replace the fuel filter during the first 50 hours service (after 50 hours and after 100 hours). After this,
replace the fuel filter at the intervals specified in Routine 'Maintenance Table'.
• Check clutch pedal travel in the mechanical version.
• Check the brake pedal free play.
• Check all oil levels. If necessary, top up with oil of the prescribed type.
• Check the tension of the fan belt.
• Grease to all grease nipples.
• Check to make sure that all bolts, screw and nuts are correctly torque.
• Check the tire's pressure.
5.6 How to prevent pollution
To prevent pollution when oil, filters and so forth are changed, always clean the zone around fill, level
and drain plugs, dipsticks and filters. Before connecting the auxiliary cylinders, make sure that the oil
they contain is clean, that it has not deteriorated owing to long storage and that it is of the prescribed
type.
5.7 Serving intervals
The intervals suggested in the lubrication and maintenance table are indications to use when the tractor
is used in normal conditions. These intervals should be adapted to the real environmental and
operational conditions. Serving must be more frequent in adverse work conditions (in the presence of
humidity, mud, sand, very dusty environments).
CAUTION: If carried out at the prescribed intervals, the operations described in this section
will ensure that the tractor operates in a regular way. However, remember to carry out the
inspections and adjustments (of variable frequency depending on the environmental
conditions and type of work carried out) according to your discretion and experience.
To Next Page
Loading...