OPERATOR MANUAL |CAPTAIN 273 4WD 66
WARNING: Avoid injury! Make certain all parts are installed correctly.
Safety belts can be fitted, depending on the laws in force in the various countries of use. Always wear
the safety belts with the protective structure in the upright position. Never wear the safety belts when
the protective structure is lowered.
If the tractor must pass through low places or be parked there for maintenance purposes and the top
part of the protective structure must be folded at an angle remember that there is not enough protection
for the tractor driver in this position and that he could risk serious injury.
Remember that after use in low places, it is absolutely necessary to set
the protective structure back in its upright position (Fig. 4-18) before
continuing with any work.
Com ply with the following procedure if it is essential to fold down the
protective structure for the above reasons (Fig. 4-17 and Fig. 4-18):
Remove the fixing pins (2).
Overturn the protective structure (1) until it rests on
The stopper.
Fit the fixing pins (2) and relative nuts as illustrated.
Before you use the tractor again in any way, set the protective
structure (1) back in the upright position (Fig. 4-18) by carrying
out the operation described above in reverse order. Fit the
fixing pins.
To avoid loosening of structure the protection offered by the safety structure will be impaired if it is
subjected to structural damage, as in an overturn accident, or is in anyway altered by welding, bending,
drilling or cutting. A damaged safety structure should be replaced, NOT reused. Always keep upper part
of the safety structure pinned in vertical position (as in the above Fig.4-18) when operating the tractor.
To Next Page
Loading...
