Cardinal 185

8400-0181-OM Rev C  185 and 185B Installation & Technical
17
Unit1= (Weighing Unit 1)
Press the TARE  key to view the current setting. To keep the current setting, press the
TARE  key again. Otherwise, press the Fn/
▲
key to scroll through the available values.
When the desired value is displayed, press the TARE  key to select the displayed value
and proceed to the next prompt.
Available values are:
1 = lb (Pounds) 2 = kg (Kilograms) 3 = oz (ounces) 4 = g (Grams)
Int= (Interval Setting)
Press the TARE  key to view the current setting. To keep the current setting, press the
TARE  key again. Otherwise, press the Fn/
▲
key to scroll through the available values.
When the desired value is displayed, press the TARE  key to select the displayed value
and proceed to the next prompt.
Available values are 1, 2, 5, 10, 20, or 50.
dPP= (Decimal Point Position)
Press the TARE  key to view the current setting. To keep the current setting, press the
TARE  key again. Otherwise, press the Fn/▲ key to scroll through the available values.
When the desired value is displayed, press the TARE  key to select the displayed value
and proceed to the next prompt.
Available values are:
0 = XXXXXX 1= XXXXX.X 2 = XXXX.XX 3 = XXX.XXX
CAP= (Capacity)
Press the TARE  key to view the current setting. To keep the current setting, press the
TARE  key again. Otherwise, use the Fn/ and UNITS/ keys to enter a new value. When
the desired value is displayed, the TARE  key to select the displayed value and proceed to
the next prompt.
Available values are 1 through 999999.
Unit2= (Weighing Unit 2)
Press the TARE  key to view the current setting. To keep the current setting, press the
TARE  key again. Otherwise, press the Fn/▲ key to scroll through the available values.
When the desired value is displayed, press the TARE  key to select the displayed value
and proceed to the next prompt.
Available values are:
0 = Disabled 1 = lb (Pounds) 2 = kg (Kilograms) 3 = oz (ounces) 4 = g (Grams)
NOTE: The selection for Unit2 cannot be the same as Unit1. In addition, for
some settings of int (interval) and dpp (decimal point position), not all unit
combinations are available.