8555-M210-O1 Rev R 758C Owner’s 7
INSTALLATION, CONT.
Battery Status
If batteries are used, the indicator will show battery status on power up. The display will show
battry then change to ð YY ð, where YY indicates remaining battery voltage expressed as a
percentage (%) of total battery voltage
Low Battery Indicator
When batteries are near the point they need to be replaced (Alkaline) or recharged (NiCad or
NiMH), the low battery annunciator on display will turn on. (See Figure No. 5 or 6). If the
battery voltage drops too low for accurate weighing, the indicator will automatically shut off and
you will be unable to turn it back on.
Using Alkaline Batteries
When the low battery annunciator turns on, turn the indicator off, remove the old batteries
and replace with new ones.
Using NiCad or NiMH Batteries
When the low battery annunciator turns on, turn the indicator off, remove the discharged
batteries and replace with fully charged ones. Place the discharged batteries in an external
charger to recharge.
Battery Installation/Replacement
To install or remove the batteries, the following steps should be followed:
1. Make sure the AC power adapter is unplugged.
2. Remove the indicator from the mounting bracket and turn the indicator over so that the
display is facing away from you.
3. Locate the rectangular panel on the back of indicator and remove the thumb screw.
4. Remove the panel (lift straight up and slide it out) exposing the battery holder.
5. If installing new batteries, proceed to step 6. If replacing the batteries, remove all 6
batteries from the battery holder and then proceed to step 6.
6. Install the new 6 "C" size batteries in the holder, noting the polarity markings located in
the battery holder. Refer to Figure No. 4.
7. After placing all 6 batteries in holder, replace panel on back of indicator (slide tab into
slot on rear panel) and install thumb screw.
8. Turn the indicator over (display facing up) and press the ON/OFF key.
9. If display turns on, batteries have been installed correctly. If not, remove panel and
check for one or more improperly positioned batteries.
10. Return the indicator to the mounting bracket.
11. The indicator is now ready for operation.
Figure No. 4
To Next Page
Loading...
Need help?
General
