8555-M210-O1 Rev R 758C Owner’s 4
INSTALLATION
Unpacking
Carefully remove indicator from shipping carton and inspect it for any damage that may have
taken place during shipment. Keep carton and packing material for return shipment if it should
become necessary. The purchaser is responsible for filing all claims for any damages or loss
incurred during transit.
Should your indicator come already installed on a scale, the following installation
information does not apply to you.
Mounting
The indicator may be mounted (using an optional bracket) to a desktop, table or bench. It can
be mounted on a wall using the two (2) holes in the mounting bracket and two (2) #10 screws
placed 2.00 inches (51 mm) apart in the wall.
To install indicator on bracket, push latch release down flush with back of indicator and hold.
Next, place large end of slotted holes in bracket over screw heads on back of indicator. Pull
down to secure indicator. Release latch release to lock indicator to bracket. See Figure No. 1.
Regardless of how and where you mount indicator, it should be in a safe area where it will not
be in the way of normal traffic. The location chosen should be free of temperature extremes
and water, is not subject to direct sunlight and should be mounted where the display is easily
viewed and within easy reach of the operator.
If wall mounted, make certain the structure and mounting bolts are of sufficient strength to
support the indicator. The mounting bracket should be securely fastened to the wall so it
cannot break loose.
Latch
Release
Latch
Figure No. 1
Bracket Mount
Screws
Thumb Screw
Battery Door
To Next Page
Loading...
Need help?
General
