8555-M210-O1 Rev R 758C Owner’s 15
OPERATION, CONT.
Body Mass Index (BMI) Operation
Using Mechanical Height Rod or Manually Entering Height
1. Press ON/OFF key to turn indicator on.
2. Press ZERO key to zero weight display. ZERO, GROSS and lb, oz, kg or ST annunciator
will turn on to show scale is ready for use.
3. Perform tare operation if required. Refer to Push Button Tare or Tare Weight Entry in
previous section for instructions on using tare.
4. Place patient on the scale and then press ID/HEIGHT key.
5. If Pounds Only or Pounds/Kilograms was selected for Unit= in setup, display will change
to show FEEt=.
a. Use numeric keys to enter 1 digit for height in feet, then press PRINT/ENTER key.
b. Display will change to show inCH=.
c. Use numeric keys to enter up to 3 digits (11.9 max.) for height in inches and then
press PRINT/ENTER key or press PRINT/ENTER key if no inches are required.
6. If Kilograms Only, Kilograms/Pounds or Stones and Pounds or Kilograms was selected for
Unit= in setup, display will change to show Cn=_.
a. Use numeric keys to enter up to 4 digits (# # # . #) for height in centimeters and then
press PRINT/ENTER key.
7. Read weight and BMI displays.
8. If a printer is connected to scale, press PRINT/ENTER key to print a ticket.
9. Remove patient from scale.
10. If Tare operation was performed, press NET/GROSS key to return to Gross weight mode.
11. Press ZERO key. This will reset tare weight to zero.
12. BMI display will clear when weight returns to zero.
Body Mass Index (BMI) Operation with ID
Using Mechanical Height Rod or Manually Entering Height
1. Press ON/OFF key to turn indicator on.
2. Press ZERO key to zero weight display. ZERO, GROSS and lb, oz, kg or ST annunciator
will turn on to show scale is ready for use.
3. Press ID/HEIGHT key.
4. Display will change to show id=.
5. Using numeric keys, key-in up to an 11 digit identification number.
6. Press PRINT/ENTER key.
7. Place patient on the scale and then press ID/HEIGHT key.
8. If Pounds Only or Pounds/Kilograms was selected for Unit= in setup, display will change
to show FEEt=.
a. Use numeric keys to enter 1 digit for height in feet, then press PRINT/ENTER key.
b. Display will change to show inCH=.
c. Use numeric keys to enter up to 3 digits (11.9 max.) for height in inches and then
press PRINT/ENTER key or press PRINT/ENTER key if no inches are required.
9. If Kilograms Only, Kilograms/Pounds or Stones and Pounds or Kilograms was selected
for Unit= in setup, display will change to show Cn=_.
a. Use numeric keys to enter up to 4 digits (# # # . #) for height in centimeters and then
press PRINT/ENTER key.
10. Read weight and BMI displays.
11. If a printer is connected to scale, press PRINT/ENTER key to print a ticket.
12. Remove patient from scale.
13. If Tare operation was performed, press NET/GROSS key to return to Gross weight mode.
14. Press ZERO key. This will reset tare weight to zero.
15. BMI display and ID will clear when weight returns to zero.
To Next Page
Loading...
Need help?
General
