8555-M210-O1 Rev R 758C Owner’s 14
OPERATION, CONT.
Basic Operation with ID
To Weigh
1. Press ON/OFF key to turn indicator on.
2. Press ZERO key to zero weight display. ZERO, GROSS and lb, oz, kg or ST
annunciator will turn on to show scale is ready for use.
3. Press ID/HEIGHT key.
4. Display will change to show id=.
5. Using numeric keys, key-in up to an 11 digit identification number.
6. Press PRINT/ENTER key.
7. Place patient on scale
8. Read weight display.
9. If a printer is connected to scale, press PRINT/ENTER key to print a ticket.
10. Remove patient from scale.
Push Button Tare (Tare weight is NOT known)
1. In Gross Weight mode (GROSS annunciator
on), place item (wheelchair, walker, etc…) to
be tared on scale.
2. Press TARE key.
3. Display will show weight of item on scale and TARE annunciator will turn on.
4. Press PRINT/ENTER key.
5. Display will change to zero and NET annunciator will turn on to show that net weight
is being displayed. The item's weight has been entered as "tare weight".
6. Press ID/HEIGHT key.
7. Display will change to show id=.
8. Using numeric keys, key-in up to an 11 digit identification number.
9. Press PRINT/ENTER key.
10. Proceed with weighing operation.
Tare Weight Entry (Tare weight is known)
1. In Gross Weight mode (GROSS annunciator on), press TARE key.
2. Display will show 0.0 or previously entered tare and TARE annunciator will turn on.
3. If weight displayed is acceptable, press PRINT/ENTER key to save it. Otherwise,
use the numeric keys and enter a new tare weight. Note that when entering tare
weights, a maximum of 4 digits can be entered and the numbers advance from right
to left in the display. The number of leading or trailing zeros required to obtain your
desired tare is dependent upon the DIVISION VALUE selected in the setup
procedure.
For example: Division Value: 0.2
Desired Tare Value: 1.6 lb
Key Sequence: 1 6
1. After the new tare weight has been entered, press PRINT/ENTER key.
2. Display will show a minus Net weight and NET annunciator will turn on.
3. Press ID/HEIGHT key.
4. Display will change to show id=.
5. Using numeric keys, key-in up to an 11 digit identification number.
6. Press PRINT/ENTER key.
7. Proceed with weighing operation.
IMPORTANT! Tare entry is not
allowed if Auto Hold is enabled.
To Next Page
Loading...
Need help?
General
